AGP 3.0 Calibration Cycle

5/5 - (15 votes)
5/5 - (15 votes)

AGP 3.0 Calibration Cycle

Option name:

AGP 3.0 Calibration Cycle

Possible values of an option:

[Enabled], [Disabled]

The option description:

Switching-on of cycles of calibration for bus AGP of the specification 3.0. These cycles are necessary to compensate change of temperature and drift of pressure of a supply, saving thus integrity of the transmittable data. It is recommended to use always this possibility ([Enabled]), differently you can face unstable operation of the videocard (hangup, inexplicable jerks at an output of a three-dimensional drawing).

Leave a Reply

Your email address will not be published. Required fields are marked *

Share via
Copy link
Powered by Social Snap