DRAM Power Voltage

4/5 - (15 votes)
4/5 - (15 votes)

DRAM Power Voltage

Option name:

DRAM Power Voltage

Possible values of an option:

Depend on storage type

The option description:

Allows to specify pressure of a supply of units of storage manually. For SDRAM units normal it is considered pressure in 3.3 In, for DDR SDRAM — 2.5 In (though many vendors of motherboards recommend 2.6 ), for DDR2 SDRAM — 1.8 In and for DDR3 SDRAM — 1.5 Century

Setting of the uprated pressure of a supply normally practises at acceleration — the given measure allows to reach higher frequencies of operation of storage, simultaneously saving comprehensible time delays at reversal to it. If you are not engaged overclocking, it is better to leave regular pressure of a supply of units of storage.

It is not recommended to increase pressure of a supply of units of storage more than on 0.2 In rather regular values (especially for the conventional memory which has been not addressed overclockers), the probability of an output of units out of operation differently is great. Do not forget about sufficient cooling (additional case fans) at acceleration of units of storage — the magnification of pressure of a supply noticeably raises their thermal emission.

Other options identical to destination:

Adjust DDR Voltage

Adjust DDR2 Voltage

Adjust Extra DIMM Voltage

DDR Power Voltage

DDR Reference Voltage


DDR Voltage

DDR Voltage Adjust

DDR2 OverVoltage Control

DDR2 Voltage

DDR2 Voltage Control

DIMM OverVoltage Control

DIMM Voltage

DIMM Voltage Adjust

DIMM Voltage Control

DIMM Voltage Select

DRAM Voltage

DRAM Voltage Select

Memory Voltage

Memory Voltage Adjustment

Memory Voltage Regulator

VDIMM Voltage

Vdimm Voltage Control

VDIMM Voltage Select

4 thoughts on “DRAM Power Voltage

Leave a Reply

Your email address will not be published.

Share via
Copy link
Powered by Social Snap