Serial Port 2 Mode

5/5 - (9 votes)
5/5 - (9 votes)

Serial Port 2 Mode

Option name:

Serial Port 2 Mode

Possible values of an option:

[Normal], [IrDA], [ASKIR]
Or
[Normal], [IrDA], [Sharp-IR]

The option description:

Some time ago for communication on small distances (we will tell, between a mobile phone and the computer) the infra-red port was often used. This device can be met in three variants of execution: first, the infra-red priemo-transmitter can be connected to one of computer COM-ports, secondly, for these purposes the USB-port can be used, thirdly, the priemo-transmitter can be connected to a special socket on the motherboard. And if first two variants demand only installation of drivers in the latter case, a pole to everything, it is necessary to execute certain options in BIOS Setup.

The described option just also allows to configure the second serial port (COM2) for work in a mode of infra-red port. Naturally, it is a question only of the infra-red priemo-transmitter connected to a special socket on the motherboard. The second COM-port is thus disconnected.

Value by default — [Normal] — assumes that the second serial port functions in a usual mode. Variants [IrDA] and [ASKIR] ([Sharp-IR]) say that the corresponding equipment is connected to a socket on the motherboard, and the second COM-port is used as the infra-red. Distinction between them — in concrete realisation of the infra-red interface. [IrDA] says that firm HP specifications (HPSIR — Hewlett-Packard Serial InfraRed) are used, [ASKIR] (or [Sharp-IR]) — that the realisation offered Sharp (ASKIR means Amplitude Shift Keyed Infrared Port) is chosen. At a value choice it is necessary to mean that variant HP faster offered Sharp, besides it is supported by a considerable quantity of devices.

Other options identical to destination:

COM 2 Mode

COM Port 2 Mode

IR Function Select

Port2 Mode

Serial Port B Mode

UART 2 Mode

UART Mode Select

UART2 Use Infrared

Share via
Copy link
Powered by Social Snap